DISC STEAM TRAP

TYPICAL APPLICATIONS

DRIP, TRACER: The WD600 thermodynamic steam traps are

commonly used as drip traps on steam mains and steam

supply lines. These traps can be used on tracing applications;

however, thermostatic traps are normally recommended for

this service. Ideal for outdoor applications that are subject

to freezing and for superheated steam conditions.

HOW IT WORKS

The thermodynamic trap has cyclic on-off operation with a

disk that is pushed open by incoming condensate and closes

tightly when steam tries to escape.

FEATURES

• High pressure applications up to 600 psig

• Hardened stainless steel seat and disc for extended service

life even at high pressure

• Single trap will operate over the entire pressure range

(3.5-600 psig)

• Unaffected by superheated steam

• Freezeproof when trap is piped in a vertical orientation

for complete drainage of condensate

• Three hole balanced discharge extends life of the seat area

• Trap will function in any orientation (horizontal preferred)

SAMPLE SPECIFICATION

The steam trap shall be a thermodynamic disc type with all

stainless steel construction. Integral seat design and disc to be

hardened for long service life. Unit shall be capable of installation

in any orientation and self-draining when mounted vertically.

INSTALLATION

Trap can be installed in any position; however, horizontal is

preferred. Installation should include isolation valves and a 20

mesh strainer. Do not weld or damage can occur to the seat area.

MAINTENANCE

Dirt is the most common cause of premature failure. For full

maintenance details, see Installation and Maintenance Manual.

OPTIONS

An insulation cap is available to reduce cycle rates and steam

loss in rain, snow, or cold environments.

 

List Price for the Stainless 3/8" NTP Disc Steam Trap is $130.00 each plus S & H and sales tax when applicable.

Great for Steam Engine Feed Water Heaters or Oil Heaters for Oil Atomization