V-TWIN STEAM ENGINE KIT

HIGH QUALITY MACHINED CASTINGS

This engine is truly a Gem of a Project!

STEAM ENGINE V-TWIN

Bore ½”

Stroke ¾” (X2) Twin Cylinder

Double Acting

This unique engine has forward, reverse and speed control capabilities, using a single lever which can be driven by a servo for radio control.  Think of it.  Just one servo can do all of this! Stop! Go Forward! Go Aft!  And control the speed in both directions!

This engine features a cast bronze base and frames, plus oilite bronze sleeve bearings on the crank shaft and piston rod.  The crank pin bearings are machined from solid bronze which run on a ground pin.  It also has a precision ground stainless steel piston rod with “O” ring seals.  The light weight aluminum cylinders are hard anodized to give you long wear.

We are using these as a Booster on our 1 ½ and 2” Scale Atlantic's very successfully.  We are also using this Engine to drive a coal stoker which requires forward and reverse capabilities.

Approximate dimensions are 2 ½” high, 4 ½” wide and 3 1/8” long parallel to the shaft.  The crankshaft is 3/16” diameter precision ground stainless steel.  The steam inlet and outlet are both threaded 3/16” 40 TPI.  

This kit comes completely machined for easy assembly.

You may use a pair of Wooden Blocks and a "C" Clamp to press the Bearings in if you do not have a press.

This is a great Engine Kit not only for our Marine but also our Stationary Steam Enthusiasts.

You must posses a mechanical aptitude and the ability to understand and read basic mechanical drawings and instructions.  This Engine is rated at approximately 1/4 Horse Power.

Factory Price is $159.00 and Our Price is $150 plus S & H

PRICED TO MOVE! 
THIS IS A LIMITED TIME OFFER!

Our Company is the Licensed Distributor/Dealer for this Equipment!

THIS ENGINE KIT IS LISTED BELOW MANUFACTURER'S LIST PRICE!